support

Your question answered

I have configured an Aprisa XE link and have good SNR and RSSI readings at both ends of the link but cannot see the remote end i.e. no remote comms. Why is this?

This can be a result of many factors:

  • Incorrect IP address configuration
  • Modulation does not match up on both ends of the link
  • Ethernet switch setting do not match up on both ends of the link
  • Ethernet traffic (configured through Cross Connections) does not match up on both ends of the link
  • Modem interleaver mode does not match up on both ends of the link
  • MHSB settings not configured correctly

Ensure that all of the above is done correctly, if you are still unsure on how to fix this issue please contact support@4rf.com